Hightech Signs can produce Do-It-Yourself Installation Signs and Lettering for you. With our ready to go vinyl letters and graphics, you can adhere our vinyl to almost any clean non-porous surface. Check out our easy- to- follow instructions below.

STEP 1 - Surface Preparation

Use a tape measure or a ruler to determine the exact area where the sign will be placed. We recommend drawing a horizontal guide line and a vertical line in the center. Make sure the surface is clean. If needed, clean the surface with a clean, dry cloth.

STEP 2 - Prepare Do-It-Yourself Installation Signage

Hightech Signs will provide you with vinyl that has transfer tape (looks and feels like white masking tape) on one side and backing paper (white and shiny) on the other. Carefully peel the backing paper away from the letters; your graphic should remain on the transfer tape.

STEP 3 - Vinyl Application

Place the taped vinyl on the pre-measured surface, using the lines to position the vinyl correctly onto the surface. Press any air bubbles out from underneath the sign. Start in the middle and press towards the edges of the letters or the graphic. Once the air bubbles are gone, firmly press the vinyl onto the surface. Any final air bubbles can be removed with a needle or sharp knife point.

STEP 4 - Transfer Tape Removal

Carefully peel back the transfer tape. This will leave the vinyl letters or the graphic on your surface.

Applications for Do-It-Yourself Installation include:

	Seasonal Promotions
	Special Advertising
	Window Graphics
	Vehicle Lettering
	Custom Graphics and Logos